Today, with the rapid development of science and technology, with the rising labor costs, especially the accuracy requirements of customers for products, the requirements for safety, automation, product quality and efficiency are getting higher and higher. The work will be gradually replaced by automatic loading and cutting machines, and this trend has slowly extended from large glass processing companies to small and medium-sized glass processing companies.

So how do you choose a glass cutting machine?

Take the special shaped automatic glass cutting machine as an example. Pay attention to the following points when purchasing:

1. Selection: According to the actual cutting sizes of glass sheets, choose the suitable machine for the workshop, so it can save equipment and investment’s cost.

2. Cutting accuracy: According to your actual demands, this can check the introduction of the plant’s product’s manual and suggestion. Go to the spot to see the actual work details.

3. Cutting speed: The cutting speed is a major performance of the cutting machine. Only when the overall performance and compatibility of the mechanical and control parts are good, the cutting machine can reach the corresponding speed, The cutting speed is one of important item for judging the performance of the glass cutting machine.

4. Automatic graphic’s optimization function: The optimization of glass graphics is an important guarantee for the high and low glass cutting rate for finished products. The one-time optimization of the computer may not achieve the best results. Sometime it should use manual modification to  optimize the designed cutting graphics to reach the good cutting effects.

5. Mechanical parts: The guarantee of stability and precision, the rationality of the design and installation of the mechanical parts will be an important factor. To ensure the flatness of the mechanical parts, the parallelism of the guide rails on both sides.

6. Function: The function of the cutting machine is also an important indicator to judge a good glass cutting machine. Does the machine can adjust the pressure automatically? Does the machine have special-shaped graphic’s scanning function? Can you have the lower cuter limit function? and so on.